PDA

View Full Version : M/C parts, new & used


Bt Doctur
02-10-2008, 10:39 AM
All kinds of items, motors to drives. some Volvo items.
Email your needs, might just have it
Alpha 1.84 complete
Alpha upper 1.98 (2)
OMC tru-course stringer drive
MC transom assembly
btdoctur@verizon.net

Bt Doctur
02-17-2008, 01:46 PM
SPECIAL CONSIGNMENT
Alpha transom assembly sold,
others available
btdoctur@verizon.net

Crums
02-17-2008, 10:02 PM
Do you ever run into any borg warner velvet drive transmissions for a nautique?

Bt Doctur
02-17-2008, 10:12 PM
Come across them in inboards sometimes, nothing right now

Bt Doctur
03-02-2008, 05:56 PM
Alpha steering yoke, upper and lower pins, steering arm.
reconditioned ,no slop. $150.00 + shipping
"boat levelor" trim tab hyd pump motor NEW $50.00+ shipping.
email your needs, might have it
btdoctur@verizon.net

waybomb
03-03-2008, 07:43 PM
Can you save me some money on two Thunderbolt IV coils? I have one, and the number on it seems to be392-805570-1. It is a new one, but the coil bracket may have eroded some of the end numbers off. I need two more, with brackets.

Thanks
Fred

Bt Doctur
03-04-2008, 09:54 PM
coil number is 805570A2, coil brackets 65970T1
42.00 list 4.69 list.
wouldnt even sell a used one,I keep 1 for testing.Been bit a few times so i junk them.
We boaters spend more on fuel, food, and beer .Ignition systems need to be top notch or your asking for trouble.Even at list there not hard to take considering the outcome should one go bad at the wrong time.

Doc
03-05-2008, 06:47 AM
Hey Bt Doctur,
I"m needing one (maybe two) rudders for a Gibson 50ft houseboat. I priced them from Gibson and they run $690 each. That price is making me think I can get by with just one for now. They come with a shaft and rudder. Gibson said to unbolt the shaft from inside the engine compartment (will drop it all down) then remove the old one and put on the new.
So just a short shaft section comes with the rudder.

Bt Doctur
03-15-2008, 07:42 PM
Just arrived for big block chevy
roller rockers with studs ,nuts,pushrods, girdles,guide plates,roller lifters
like new, removed from a new motor.
Make offer

waybomb
03-16-2008, 11:35 AM
Brand? Ratio? What kind of girdle?

Bt Doctur
03-16-2008, 03:36 PM
for the above parts post for BB
marked as 1.7 on the rocker

waybomb
03-16-2008, 11:09 PM
Oh, I thought they may be Crane hardware. Looking to build a spare for my 17 footer.

Bt Doctur
03-17-2008, 07:57 PM
Sierra 18-2412 coupler for SM or BB Chevy. Bravo drive ,round type bolts to flywheel
New in box $364.00 + shipping
Used 4bbl intake Vortec fits Q -Jet carb (4bolts under carb are straight not angled) $300.00+shipping
Yahama carbs off 200hp w/ airbox $300.00 + shipping
btdoctur@verizon.net

Bt Doctur
03-28-2008, 07:44 PM
Just found
USED dist.for 470-488 motor good cond. no shaft play, hex drive for oil pump $100.00+ shipping
USED 1.98-1 gearset for mercruiser,no impacts $100.00 + shipping
USED 1.32-1 gearset, big block /alpha drive $100.00 + shipping
Cast 4bbl intake Ford 302 never in marine use. $200.00+shipping
dist. for Volvo inline 6 $75.00+ shipping
inline 6 starter for same $50.00+ shipping
Volvo intake W/ carbs (3 SOLEX) $150.00+ shipping
btdoctur@verizon.net

Bt Doctur
06-28-2008, 02:14 PM
Late model power steering unit. Does not have the 2 lines that rust out.
$200.00 + shipping.
btdoctur@verizon.net